Table of Contents
Advertisement
Event
Description
ID
*Reserved
109
Optics Block Dirty
110
- Cleaning Required
Sample Pressure High
111
112
*Reserved
Pump Over Temperature
113
High Exhaust Pressure
114
Power Supply failure
115
Optics Temperature Out of Range
116
*Reserved
117
118
Filter Timer Expired
Optics Cleaning Timer Expired
119
120
Pump Maintenance Timer Expired
121
*Reserved for LIT option
Vertex
TM
C System
Possible Cause
Optic block dirty
Optic block is aged
Tape leader installed improperly
End of line filter clogged
Sample line kinked
Too small ID and/or Maximum line length exceeded
Crimped tube in cable carrier
Fan failure
Line voltage less than 342VAC or higher than 418VAC when high
voltage(380VAC) is applied
Line voltage less than 198VAC or higher than 242VAC when low
voltage(220VAC) is applied
Thermal Switch connections loose
Kinked exhaust
Exhaust tubing length exceeds 50ft. (15m.)
Exhaust line restricted
Power line disconnected
Hot or Cold environment
Electronic problem
Cooling air failure
Maintenance reminder, no malfunction
Maintenance reminder, no malfunction
Maintenance reminder, no malfunction
Clean optics.
Contact Honeywell Analytics Service.
Replace optics block
Reload Chemcassette® and recalibrate using leader
Replace end of line filter
Isolate by disconnecting possible crimped sample line
Check sample tube ID and length
Identify crimps in tubing harness by checking pressure with analyzer closed vs. open
Check fans in pump module
Verify main line voltage
Check the connections to the Thermal Switch. Sensor located in the middle of the top cover of
the pump cabinet.
Check exhaust tubing for kinks or restrictions
Reroute to reduce length
Clean Exhaust line
Replace Exhaust line
Check power line from PDU to Analyzer
Relocate Vertex™ VC4
Replace optics block
Replace fans
Change filter and reset timer
Clean the Optics and reset timer
Rebuild pump and reset timer
145
Resolution
User Manual
Advertisement
Table of Contents
