Speaker Setting - Yamaha DVD-S1200 Owner's Manual

POWER
/ I
Í
1
5
9
SET UP
VIDEO OFF
TOP MENU
ON SCREEN
PLAY MODE SUBTITLE
Main (L)
A
SETUP
L
Exit
Exit
Test
SELECT
Test
LS
ENTER RETURN
signal
(L) (L)
A
A
No Large
B
L
C
a
LS
Center speaker
Difference
Approx. 50 cm
Approx. 100 cm
Approx. 150 cm
Approx. 200 cm
Rear speakers
Difference
Approx. 200 cm
Approx. 400 cm
Approx. 600 cm
AUDIO/VIDEO
OPEN/CLOSE
2 3 4
6 7 8
CANCEL
0 1 0
S
MARKER
GROUP PAGE
MENU
Cursor buttons/
ENTER
RETURN
ENTER
AUDIO ANGLE
Center Main (R)
B A C A
R
ms dB
C
0 0
dB
SW
0
dB ms dB
RS
0 0 0
Rear Subwoofer
(R) (R)
C B C A C
LS
LS
Small
R
b
SW
c
RS
Setting
1.3 ms
2.6 ms
3.9 ms
5.3 ms
Setting
5.3 ms
10.6 ms
15.9 ms
Changing settings

Speaker setting

Select either "2-channel" or "Multi-channel" to suit the speakers you
have connected. You can change the following settings when you
select "Multi-channel".
Speaker presence and size
A
1. Use the cursor buttons [ ,
press [ENTER].
2. Press the cursor buttons [ ,
press [ENTER].
Icon examples: Rear speaker (L)
Large: When the speaker supports low-frequency (under
100 Hz) reproduction.
Small: Select when the speaker does not support low-frequency
reproduction.
The size setting for the main speakers is automatically determined by
the setting for the subwoofer.
Delay time
B
(Dolby Digital, center and rear speakers only)
For optimum listening with 5.1-channel sound, all the speakers, ex-
cept for the subwoofer, should be the same distance from the seating
position. If you have to place the center or rear speakers closer to the
seating position, adjust the delay time to make up for the difference.
If distance (from the center speaker) and
ers) are the same as or greater than
leave the delay time as "0", the factory preset.
If either distance or
relevant table and change to the recommended setting.
Changing the delay time
1. Use the cursor buttons [ ,
box and press [ENTER].
A
2. Press the cursor buttons [ ,
press [ENTER].
C Speaker balance
1. Use the cursor buttons [ ,
press [ENTER].
A test signal is output from one speaker at a time, starting with the
main left speaker and proceeding clockwise.
MAIN (L)-)CENTER--)MAIN (R)
e
REAR (L)(----------------==REAR (R)
2. While listening to the test signal, press the cursor buttons
[ , ] to adjust the volume of the center and rear speakers
so they are the same apparent volume as the main speakers
( 6 dB to 6 dB).
(The main speakers cannot be adjusted here.)
3. Press [ENTER].
The test signal stops.
Note
Test signal is effective only when you made analog connection.
When you make digital connection, make adjustment using the test
tone on the amplifier.
No signal is output for the subwoofer. To adjust its volume, play
something, then return to this screen to adjust to suit your taste.
When you are finished
Use the cursor buttons [ ,
[ENTER].
Note
The unit may be unable to output as set here due to limitations im-
posed by the unit itself or the disc being played. (The FL display's
"P.PCM" indicator lights or "D.MIX" indicator goes out in these
cases.)
, , ] to select the item and
] to select the setting and
(from the rear speak-
(from the main speakers),
is less than , find the difference in the
, , ] to select the delay time
] to adjust the delay time and
, , ] to select "Test" and
v
, , ] to select "Exit" and press
27