Maintenance - Yamaha DVD-S1200 Owner's Manual

Sound
Piercing noise comes from the
speakers.
Picture
Picture distorted.
No picture.
The picture shown on the
television is not normal.
(The sides of the picture are cut
off or black bands appear at the
top and bottom of the screen.)
There is a lot of ghosting.
Displays
"No Play" appears on the unit's
display.
No on-screen display.
GUI screens not displayed or only
partially displayed on the
television.
The disc's menu is displayed in a
different language.
No menu play.
"Check The Disc" appears on the
unit's display.
"H " appears on the unit's
display.
stands for a number.
"No Disc" appears on the unit's
display.

Maintenance

To clean this unit, wipe with a soft, dry cloth.
Never use alcohol, paint thinner or benzine to clean this unit.
Before using chemically treated cloth, read the instructions that came with the cloth carefully.
If you have connected this unit to other equipment through the DIGITAL AUDIO OUT terminal,
ensure you have selected the correct settings for "Dolby Digital", "DTS Digital Surround" and
"MPEG" in the SET UP menus' Audio menu.
Some distortion is normal during SEARCH.
The screen may be disrupted briefly when you turn off the VIDEO OFF feature.
Ensure that the equipment is connected properly.
Make sure the television is on.
Ensure the television's video input setting (e.g., VIDEO 1) is correct.
Go to the Video menu in the SET UP screen, and change "TV Aspect" to suit your television.
You may also need to change the screen mode on the television itself.
Ensure that the unit is not connected through a video cassette recorder.
Use the on-screen menu icons to adjust the picture quality.
You inserted a disc the unit cannot play; insert one it can.
Go to Display in the SET UP menus, and select "On" for "On-Screen Messages".
Move the cursor buttons [ , ] while the rightmost icon is highlighted to move them down.
Go to Disc in the SET UP menus, and select the preferred language for "Menus".
Menus are only displayed if they are recorded on the disc.
Disc is dirty. Wipe the disc clean.
Trouble is likely to have occurred. The number following "H" depends on the status of the unit.
Reset procedure:
Press [STANDBY/ON] to switch the unit to the standby mode and then back to ON. Alternatively,
press [STANDBY/ON] to switch the unit to the standby mode, disconnect the AC mains lead, and
then reconnect it.
If the service numbers fail to clear, note the service number and contact a qualified service
person.
You haven't inserted a disc; insert one.
You haven't inserted the disc correctly; insert it correctly.
31