Solid-State Drive And M.2 Solid-State Drive Bracket (For Selected Models) - Lenovo ThinkPad X13 Gen 5 User Manual

cable to the connector labeled WHITE GREY, and the black and grey cable to the connector
labeled BLACK GREY.
M.2 solid-state drive and M.2 solid-state drive bracket (for selected
models)
Follow the instructions to replace the M.2 solid-state drive and M.2 solid-state drive bracket.
Prerequisite
Before you start, read Generic Safety and Compliance Notices
Attention: If you replace a M.2 solid-state drive, you might need to install a new operating system. For
details on how to install a new operating system, see "Install a Windows operating system and drivers" on
page 48.
The M.2 solid-state drive is sensitive. Inappropriate handling might cause damage and permanent loss of
data.
When handling the M.2 solid-state drive, observe the following guidelines:
• Replace the M.2 solid-state drive only for repair. The M.2 solid-state drive is not designed for frequent
changes or replacement.
• Before replacing the M.2 solid-state drive, make a backup copy of all the data that you want to keep.
• Do not apply pressure to the M.2 solid-state drive.
• Do not touch the contact edge or circuit board of the M.2 solid-state drive. Otherwise, the M.2 solid-state
drive might get damaged.
• Do not subject the M.2 solid-state drive to physical shocks or vibration. Put the M.2 solid-state drive on a
soft material, such as cloth, to absorb physical shocks.
For access, do the following:
1. Disable the built-in battery. See "Disable the built-in battery" on page 52.
2. Turn off the computer and disconnect the computer from ac power and all connected cables.
3. Close the computer display and turn the computer over.
4. Remove the base cover assembly. See "Base cover assembly" on page 52.
Type 1
Step 1. Remove the M.2 solid-state drive as shown below.
56
ThinkPad X13 Gen 5 and ThinkPad X13 2-in-1 Gen 5 User Guide
and print the following instructions.