Solid-State Drive And Its Bracket (For Selected Models) - Lenovo ThinkPad L14 Gen 5 User Manual

2. Turn off the computer and disconnect the computer from ac power and all connected cables.
3. Close the computer display and turn over the computer.
4. Remove the base cover assembly. See "Base cover assembly" on page 52.
Note: A Mylar film might cover the memory module. To access the memory module, peel off the film first. Do
not damage the mylar film and attach it in place after installation.
Step 1. Remove the memory module as shown below.
Step 2. Install the memory module in reverse order.
Memory module replacement might cause memory retraining. For details, see "Detect memory retraining (for
Intel models only)" on page 43.
M.2 solid-state drive and its bracket (for selected models)
Follow the instructions to replace the M.2 solid-state drive.
Before you start, read Generic Safety and Compliance Notices
Attention:
• If you replace a M.2 solid-state drive, you might need to install a new operating system. For details on how
to install a new operating system, see "Install a Windows operating system and drivers" on page 44.
• If your computer is installed with the color profiles, you need to reinstall the color profiles after installing a
new operating system, see "Color calibration (for selected models)" on page 29.
The M.2 solid-state drive is sensitive. Inappropriate handling might cause damage and permanent loss of
data.
When handling the M.2 solid-state drive, observe the following guidelines:
• Replace the M.2 solid-state drive only for repair. The M.2 solid-state drive is not designed for frequent
changes or replacement.
• Before replacing the M.2 solid-state drive, make a backup copy of all the data that you want to keep.
• Do not apply pressure to the M.2 solid-state drive.
• Do not touch the contact edge or circuit board of the M.2 solid-state drive. Otherwise, the M.2 solid-state
drive might get damaged.
and print the following instructions.
Chapter 6
. 55
CRU replacement