Lenovo ThinkPad X13 Gen 5 User Manual page 66

Question
How do I check my repair status?
How do I check my warranty
status?
How do I access Control Panel?
How do I turn off my computer?
How do I partition my storage
drive?
What do I do if my computer
stops responding?
What do I do if I spill liquid on the
computer?
How do I enter the UEFI BIOS
menu?
60
ThinkPad X13 Gen 5 and ThinkPad X13 2-in-1 Gen 5 User Guide
Solution
1. Go to Lenovo Support Web site at
2. Search by the product name, and navigate to the Repair Status section.
3. Enter the serial number to check the repair status.
• Go to Lenovo Support Web site at
warrantylookup#/ .
• From the Vantage app.
Type Control Panel in the Windows search box and then press Enter.
Open the Start menu and click
https://support.lenovo.com/solutions/ht503851
1. Press and hold the power button until the computer turns off. Then, restart
the computer.
2. If step 1 does not work:
• For models with an emergency reset hole: Insert a straightened paper clip
into the emergency reset hole to cut off power supply temporarily. Then,
restart the computer with ac power connected.
• For models without an emergency reset hole:
– For models with the removable battery, remove the removable battery
and disconnect all power sources. Then, reconnect to ac power and
restart the computer.
– For models with the built-in battery, disconnect all power sources.
Press and hold the power button for about seven seconds. Then,
reconnect to ac power and restart the computer.
1. Carefully unplug the ac power adapter and turn off the computer immediately.
The more quickly you stop the current from passing through the computer the
more likely you will reduce damage from short circuits.
Attention: Although you might lose some data or work by turning off the
computer immediately, leaving the computer on might make your computer
unusable.
2. Wait until you are certain that all the liquid is dry before turning on your
computer.
CAUTION:
Do not try to drain out the liquid by turning over the computer. If your
computer has keyboard drainage holes on the bottom, the liquid will be
drained out through the holes.
Restart the computer. When the logo screen is displayed, press F1 to enter the
UEFI BIOS menu.
https://pcsupport.lenovo.com
https://pcsupport.lenovo.com/kn/en/
Power. Then, click Shut down.
.