Table of Contents
Advertisement
S
P
This feature allows you to set sub-band limits for either scanning or manual VFO opera-
tion. For example, you might wish to set up a limit (in North America) of 144.300 MHz to
148.000 MHz so as to prevent encroachment into the SSB/CW "Weak Signal" portion of
the band below 144.300 MHz. Here's how to do this:
1. Set the radio to the VFO mode by pressing the [ V/M ( DW ) MT ] key, if necessary.
2. Using the techniques learned earlier, store (per the above concept) 144.300 MHz into
Memory Channel #L1 (the "L" designates the Lower sub-band limit).
3. Likewise, store 148.000 MHz into Memory Channel #
Upper sub-band limit).
4. Press and hold in the [ BAND ( SCN ) BND DN ] key for one sec-
ond, and (while holding the [ BAND ( SCN ) BND DN ] key in)
rotate the DIAL knob to select the desired PMS frequency pair
), then release the [ BAND ( SCN ) BND DN ] key.
PMSxx
(
5. Releasing the [ BAND ( SCN ) BND DN ] key to initiates the Pro-
grammable (Band Limit) Memory Scan; the Memory Channel
number will be replaced by "
just-programmed range.
6. 50 pairs of Band Limit memories, labeled
You therefore can set upper and lower operation limits in multiple segments on a
number of bands, if you like.
7. To exit from PMS operation, press the [ V/M ( DW ) MT ] key.
Please be sure only to store limit frequencies which are on the same band and
set to the same frequency steps in both the upper and lower frequency limit
memories.
52
B
L
M
Pxx
." Scanning and tuning will now be limited within the
L1/U1
S
PMS
U1
(the "U" designates the
L50
U50
through
/
VX-6R O
are available.
M
Advertisement
Table of Contents
