Table of Contents
Advertisement
then press the [ BAND ( SCN ) BND DN ] key momentarily.
6. To exit from Memory Bank operation, just press the [ BAND ( SCN ) BND DN ] key .
MEMORY
"
" will appear on the display, indicating that you are now in the "standard"
Memory Recall mode, without utilization of the Memory Banks. The memories stored
in the various Banks will remain in those banks, however; you do not need to store
them again.
Removing Memories from a Memory Bank
1. Recall the memory channel to be removed from a Memory Bank.
2. Press and hold in the [ F/W ] key for one second, then press the [
remove the memory channel data from the Memory Bank.
Changing a Memory Bank's Name
You may change the default Memory Bank Name which is indicates on the display while
selecting the Memory Bank to your desired name.
1. Press the [ F/W ] key, then press the [ 0 ( SET )] key to enter the Set mode.
2. Rotate the DIAL knob to select Set Mode Item 10: BNK NM.
3. Press the [ 0 ( SET )] key momentarily, then rotate the DIAL knob
to recall the memory bank on which you wish to change a label.
4. Press the [ MODE ( SP S ) SQ TYP ] key to enable changing of
the name tag.
5. Rotate the DIAL knob to select the first digit of the desired label.
6. Press the [ MODE ( SP S ) SQ TYP ] key to move to the next char-
acter.
7. If you make a mistake, press the [ BAND ( SCN ) BND DN ] key to
back-space the cursor, then re-enter the correct letter, number, or symbol.
8. Repeat steps 5 through 7 to program the remaining letters, num-
bers, or symbols of the desired label. A total of six characters
may be used in the creation of a label.
9. When you have programmed a name which is under 6 characters, press the [ 0 ( SET )]
key to confirm the label.
10. When you have completed the changing of the name, press the PTT key to save the
label and exit.
VX-6R O
M
M
M
B
M
R
M
O
C
( LK ) TXPO ] key to
41
Advertisement
Table of Contents
