Table of Contents
Advertisement
R
O
M
Checking the Repeater Uplink (Input) Frequency
It often is helpful to be able to check the uplink (input) frequency of a repeater, to see if the
calling station is within direct ("Simplex") range.
To do this, just press the [ HM/RV ( EMG ) R/H ] key. You'll
notice that the display has shifted to the repeater uplink fre-
quency. Press the [ HM/RV ( EMG ) R/H ] key again to cause
operation to revert to normal monitoring of the repeater
downlink (output) frequency. While you are listening on the
input frequency to the repeater using the [ HM/RV ( EMG )
R/H ] key, the repeater offset icon will blink.
The configuration of this key may be set either to "RV" (for checking the
input frequency of a repeater), or "HM" (for instant switching to the "Home"
channel for the band you are operating on). To change the configuration of
this key, use Set Mode Item 28: HM/RV. See page 45.
26
R
S
A
VX-6R O
M
Advertisement
Table of Contents
