MULTIQUIP QP2B Operation Manual page 6

Centrifugal pump
Table of Contents

Advertisement

CAUTION
„ NEVER lubricate components or attempt service on a
running machine.
„ NEVER block or restrict fl ow from a discharge hose.
Remove kinks from the discharge line before starting
the pump. Operation with a blocked discharge line can
cause water inside the pump to overheat.
NOTICE
„ ALWAYS fi ll the pump casing with water before starting
the engine. Failure to maintain water inside the pump
housing will cause severe damage to the pump and
mechanical seal.
„ In winter, drain water from the pump housing to prevent
freezing.
„ NEVER start the pump with the clean-out cover removed.
The rotating impeller inside the pump can cut or sever
objects caught in it. Before starting the pump, check that
the clean-out cover is securely fastened.
„ ALWAYS keep the machine in proper running condition.
„ ALWAYS ensure the pump is on level ground before use.
„ Fix damage to the machine and replace any broken
parts immediately.
„ ALWAYS store equipment properly when it is not being
used. Equipment should be stored in a clean, dry location
out of the reach of children and unauthorized personnel.
ENGINE SAFETY
WARNING
„ NEVER operate the engine with heat shields or guards
removed.
„ DO NOT remove the engine oil drain plug
while the engine is hot. Hot oil will gush
out of the oil tank and severely scald any
persons in the general area of the pump.
CAUTION
„ NEVER touch the hot exhaust manifold,
muffl er or cylinder. Allow these parts to cool
before servicing the equipment.
PAGE 6 — QP2B CENTRIFUGAL PUMP • OPERATION MANUAL — REV. #0 (04/06/23)
SAFETY INFORMATION
NOTICE
„ NEVER run the engine without an air fi lter or with a dirty
air fi lter. Severe engine damage may occur. Service the
air fi lter frequently to prevent engine malfunction.
„ NEVER tamper with the factory settings of
the engine or engine governor. Damage
to the engine or equipment can result
if operating in speed ranges above the
maximum allowable.
FUEL SAFETY
DANGER
„ DO NOT add fuel to equipment if it is placed inside a
truck bed with plastic liner. Possibility exists of explosion
or fi re due to static electricity.
„ DO NOT start the engine near spilled fuel or combustible
fl uids. Fuel is extremely fl ammable and its vapors can
cause an explosion if ignited.
„ ALWAYS refuel in a well-ventilated area, away from
sparks and open fl ames.
„ ALWAYS use extreme caution when working with
fl ammable liquids.
„ DO NOT fi ll the fuel tank while the engine is running
or hot.
„ DO NOT overfi ll the tank, as spilled fuel can ignite if it
comes into contact with hot engine parts or sparks from
the ignition system.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the QP2B and is the answer not in the manual?

Table of Contents