Table of Contents
Advertisement
c. Insert the tab of the shield into the hole in the rear panel and pivot the shield inward until it snaps into
position.
Figure 141. Installing the shield
d. Connect the rear Wi-Fi antenna cable to the Wi-Fi card module.
e. Reinstall the shield and insert the plug of the retention latch into the hole to secure the Wi-Fi card
module.
Figure 142. Reinstalling the shield and insert the plug of the retention latch into the hole to secure the Wi-Fi card
module
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 183.
Microprocessor
Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
CAUTION:
Avoid contact with hot components inside the computer. During operation, some components
become hot enough to burn the skin. Before you open the computer cover, turn off the computer,
disconnect power, and wait approximately 10 minutes for the components to cool.
168
P330 Hardware Maintenance Manual
Advertisement
Table of Contents
