Power Button - Lenovo 30C50064IX Hardware Maintenance Manual

c. Align the four holes in the rear of the type-2 storage-drive cage with the corresponding hooks in the
drive bay assembly. Then slide the type-2 storage-drive cage upward until it snaps into position.
Reinstall the screw to secure the type-2 storage-drive cage.
Figure 105. Installing the type-2 storage-drive cage
d. Connect the signal cable and the power cable to the new storage drive.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 183.

Power button

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
To remove or install the power button, do the following:
1. Prepare your computer. See "Preparing your computer" on page 96.
2. Locate the power button. See "FRUs and CRUs" on page 35.
3. Disconnect the power button cable from the front-bezel connector on the system board. See "Parts on
the system board" on page 38.
.
Chapter 9 Hardware removal and installation
145