Safety Notes - Hans Grohe AXOR Massaud 18013000 Manual

Safety Notes

Gloves should be worn during installation to prevent
crushing and cutting injuries.
The hot and cold supplies must be of equal pressures.
Assembly (see page 33)
Important! The fitting must be installed, flushed and
tested after the valid norms.
Technical Data
This mixer series-produced with EcoSmart®
(flow limiter).
Rate of flow with EcoSmart:
Rate of flow without EcoSmart:
Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Fault
Insufficient water
Mixer stiff
Mixer dripping

English
7 l/min 0,3MPa
14 l/min 0,3 MPa
max. 1 MPa
0,1 – 0,5 MPa
1,6 MPa
max. 80° C
65° C
Cause
- Supply pressure inadequate
- Filter at the isolation valves soils.
- EcoSmart® dirty or leaking
- Connection hose folded.
- Shut-off unit damaged
- Shut-off unit damaged
- (18013000) Spray former
defective
Hansgrohe mixers can be used together with hydraulically
and thermically controlled continuous flow heaters if the
flow pressure is at least 0,15 MPa.
If the continuous water heater causes any problems or
there is not enough flow of water, the EcoSmart® (5a)
located behind the aerator must be removed.
This mixer is equipped with a flush stream, which enhances
the natural side of the life element water. As this flush
stream does not contain any air, we recommend the use
of Axor Massaud sinks or very deep sinks to prevent
water spray.
Spare parts (see page 3)
Special accessories
58085000 special tool set (order as an extra)
Cleaning (see page 38)
Remedy
- Check water pressure (If a pump
has been installed check to see if
the pump is working).
- Clean the filter / exchange filter
- Clean or exchange EcoSmart®
- Connection hose in a bigger
radius mount.
- Exchange shut-off unit
- Exchange shut-off unit
- (18013000) Exchange spray
former