Disabling And Enabling Protocols Using The Front Panel; Disabling Protocols Using Centreware Is - Xerox Phaser 7700 Install Manual
Xerox phaser 7700: install guide
Hide thumbs
Also See for Phaser 7700:
- Service manual (379 pages) ,
- User manual (108 pages) ,
- Advanced features and troubleshooting manual (69 pages)
Table of Contents
Advertisement
Disabling and Enabling Protocols Using the Front
Panel
1.
With
highlighted, press the OK key.
Menus
2.
Scroll to
Network Setup Menu
3.
Press the OK key.
4.
Scroll to
TCP/IP Address Menu
5.
Press the OK key.
6.
Scroll to
DHCP/BOOTP, TCP/IP, EtherTalk, NetWare,
Arrow Up or Arrow Down key.
Press the OK key.
7.
8.
Scroll to display either
9.
Press the OK key.
10.
To exit the menu system, scroll to
Disabling Protocols Using CentreWare IS
1.
Connect to the printer via CentreWare IS (see page 24).
2.
On the main CentreWare IS page, click Properties.
3.
On the left side of the page, in the Protocols group, select the protocol to be disabled.
This displays the page for that protocol.
4.
On the page are fields labeled with the settings for the protocol. To disable a setting or
protocol, select Off
5.
Click Save Changes at the bottom of the page.
Networking Setup Guide
by pressing the Arrow Up or Arrow Down key.
by pressing the Arrow Up or Arrow Down key.
or
by pressing the Arrow Up or Arrow Down key.
On
Off
and press the OK key.
Exit
Network Protocols
or
by pressing the
IPP
33
Advertisement
Table of Contents
