Connecting Your Printer To A Network; Direct Ethernet Connection To Macintosh Or Pc - Xerox Phaser 7700 Install Manual

Connecting Your Printer to a Network

Direct Ethernet Connection to Macintosh or PC

Requirements
Two RJ-45, twisted-pair, 10Base-T cables


An Ethernet-port hub


Procedure
1. Turn off your computer and the printer.
2. Connect one end of an Ethernet cable to the Ethernet port on your computer. Connect
the other end to the hub.
3. Connect the other cable to the hub and the Ethernet port on the printer.
Note
The printer is not a SCSI device. Do not connect the printer to your computer
through the SCSI ports.
4. Turn on your computer and printer.
5. After the computer and printer are connected, refer to the configuration instructions
for your network type.
Networking Setup Guide
Connecting Your Printer to a Network
7700-01
3