Table of Contents
Advertisement
FLEXIDOME corner 7100i IR
4.
Setting destination 10 to the IP-address 0.0.0.0 overrides its function as the tenth address
to try.
Video transmission
If the unit is operated behind a firewall, select TCP (HTTP port) as the transfer protocol.
For use in a local network, select UDP.
To enable multicast operation, select UDP for the Video transmission parameter here and
on the Network Access page.
Note:
In the event of an alarm, a larger network bandwidth is sometimes required for additional
video streams (if multicast operation is not possible).
Stream
Select a stream to be transmitted.
Remote port
Select an appropriate browser port depending on the network configuration.
The ports for HTTPS connections are only available if SSL encryption is set to On.
Video output
If a hardware receiver is used, select the analog video output to which the signal should be
switched. If the destination device is unknown, select First available. This places the image
on the first video output with no signal.
The connected monitor only displays images when an alarm is triggered.
Note:
Refer to the destination unit documentation for more information on image display options
and available video outputs.
Decoder
If a split image is set for the selected video output, select a decoder to display the alarm
image. The decoder selected determines the position in the split image.
SSL encryption
SSL encryption protects data used for establishing a connection, such as the password. By
selecting On, only encrypted ports are available for the Remote port parameter. SSL
encryption must be activated and configured on both sides of a connection.
The appropriate certificates must also have been uploaded. (Certificates can be uploaded
on the Certificates page.)
Configure and activate encryption for media data (such as video, metadata or audio when
available) on the Encryption page (encryption is only available if the appropriate license is
installed).
Audio
Select On to transmit the audio stream with an alarm connection.
Click Set to apply the changes.
4.6.2
VCA
The camera has integrated Video Content Analysis (VCA) which detects and analyzes
changes in the picture using image processing algorithms. Such changes can be due to
movements in the camera's field of view. Detection of movement can be used to trigger an
alarm and to transmit metadata.
Various VCA configurations can be selected and adapted to your application, as required.
Bosch Security Systems
Set the user password of all the remote stations to be accessed using this password.
User Manual
Configuration | en
2023-10 | V02 | F.01U.407.683
41
Advertisement
Table of Contents
