Advertisement
B. MANUAL ROLL-UP FEATURE
This awning includes a manual roll-up gearbox
on the end of the motor, which allows the user to
stow the awning in the event of a loss of electri-
cal power or a motor problem. Hook the sup-
plier crank wand into the eyelet as shown and
crank the awning until the cassette is closed.
FIG. 13
Left hand crank side shown.
C. ADJUSTINg THE LIMITS OF THE AW-
NINg
The awning will stop at a pre-set maximum ex-
tension. It will also stop when fully retracted. If
necessary, it is possible to adjust the pre-set po-
sitions as follows using the provided hex socket
tool.
Be careful not to set the awning to over-re-
tract or it may cause damage to the awning.
If the awning is set to over-retract, the elec-
trical current setting will cause the motor to
turn off, rather than the pre-set limit device.
This will cause premature awning motor
damage if performed repeatedly.
Eyelet
Crank
110(XX)(YY).000(#) Home Cassette Awning Installation & Operation Instructions
Always make sure you count the amount of
turns while adjusting, in the event it's desired to
go back to the original setting.
1. Setting the retraction point (Hex socket #1): Ro-
tating the socket toward the negative (-) sign will
reduce the amount the awning retracts. Rotating
the socket toward the plus (+) sign will increase
the amount the awning retracts.
2. Setting the extension point (Hex socket #2): Ro-
tating the socket toward the negative (-) sign will
reduce the amount the awning extends. Rotating
the socket toward the plus (+) sign will increase
the amount the awning extends.
Motor
FIG. 14
D. AWNINg EXTENSION AND RETRACTION
SETTINgS REESTABLISHED AFTER MO-
TOR OR FABRIC REPLACEMENT
1. Extend the awning 1 foot.
2. Turn (Hex Socket #1) towards the (-) sign until it
is tight to turn. Be careful not to over tighten and
damage the plastic hex socket screw.
3. Depress the extension remote button and keep it
depressed as you turn (Hex Socket #1) towards
the (+) sign. The awning will begin to open in a
stepping motion as the hex tool turns (Hex Sock-
et #1) toward the (+) sign.
4. Stop turning the hex tool and release the re-
mote extension button when desired extension is
achieved.
7
HEX SOCKET #1
HEX SOCKET #2
Tool
Advertisement
