Advertisement
E. MOUNTINg THE AWNINg
The awning is very heavy. Ensure you have
enough assistance to support and install
the awning. Injury could result from lifting
without adequate assistance and ladders in
place.
1. Lift the awning until the cassette slides into the
wall brackets. Be sure that the power cord is
hanging from the underside of the awning.
2. Tighten the retaining bolts through the wall brack-
ets to secure the awning in place.
FIG. 10
Retaining nut and bolt
3. Tighten the bolt on the side of the bracket.
F. LEVELLINg THE AWNINg
The awning is already preset with the best level
of pitch. When fully opened, the front bar should
be level. However, if necessary, the level can
be adjusted as follows:
1. Loosen the 17mm locking nuts located on the
side of the brackets.
2. Turn the jack bolt (located in the middle screw –
covered by a plastic cap) by using a 6mm allen
wrench.
3. There is a built-in level inside the front bar that
can be used to ensure the front bar is level.
110(XX)(YY).000(#) Home Cassette Awning Installation & Operation Instructions
FIG. 11
Jack Bolt
4. The awning should be adjusted while the awning
is open. After each adjustment, check the level,
close, open and readjust if necessary.
USER'S gUIDE
A. OPERATION
To extend the awning, press the top button on
the remote. The awning will extend automatical-
ly after holding the button down for an instant.
FIG. 12
To retract the awning, press the bottom button
on the remote. The awning will retract auto-
matically after holding the button down for an
instant.
To stop the awning at any position between fully
extended and fully retracted, press the middle
button on the remote.
6
Locking Nuts
Extend
Stop
Retract
Advertisement
