Advertisement
3) If using the KVM function, connect the keyboard/mouse to the USB port
of the receiver and connect the computer to the USB port of the
transmitter via the USB cable
4) Plug the power supply into the devices to get started.
5) In the case of multiple sets being used at the same time in the same area.
In order to prevent mutual interference, switch each set of transmitters
and receivers to a different channel after they have been manually paired
with the SSID.
3. SSID Pairing
1. Enter the SSID pairing mode by holding the transmitter and receiver's
channel switch buttons for five seconds. Both WiFi connection indicators
will flash quickly in yellow.
2. When the SSID pairing is successful, the WiFi indicators on the transmitter
and receiver will change from quick flashing to slow flashing or steady on.
NO.
Channel 1
Channel 2
Channel 3
Channel 4
Frequency
5.180 GHz
5.200 GHz
5.220 GHz
5.240 GHz
8
· FAQ
Q: Why the receiver and transmitter cannot be connected, showing
"Search ipcolor Tx..." on the screen?
A: 1) Move transmitter and receiver closer.
2) Re-power the transmitter or receiver.
3) Re-pair the transmitter and receiver.
Q: Why the Wi-Fi indicator is steady on but showing "Please check the TX input
signal" ?
A: 1) Make sure the TX has HDMI input and that the resolution is within the
specified range.
2) Try to connect the signal source directly to the display device, or change
the signal source and HDMI cable and test again.
Q: Why is the display stuttering or unstable?
A: 1) Place the transmitter or receiver within the signal coverage and minimize
obstructions between the transmitter and receiver.
2) Switch to a different channel to avoid interference from other wireless
signals.
3) Re-power the receiver or transmitter.
9
Advertisement
