Lenkeng LKV372 User Manual

HDMI Extender Over Network Cable
User's manual

IMPORTANT SAFETY INSTRUCTIONS:


Do not mix up HDMI to RJ45 to HDMI sender and RJ45 to HDMI
receiver before installation.

Do not hot plug when it is working.

Use DC5V power supply only. Make sure specification matched if using

1. PACKAGE CONTENTS

HDMI to LAN sender TX*1pcs
DC5V1A*2pcs
2.INSTALLATION REQUIREMENTS
2.1.HDMI source device(computer graphics card,DVD,PS3,HD monitoring
equipment etc.
2.2. HDMI display device like SDTV,HDTV,projector with HDMI port.
2.3.UTP/STP cat6/cat6A/cat7 cable
2.4.Follow standard IEEE-568B
2.5.Transmit length more than 40m by CAT6 cable or higher level cable.
3.INTERFACES

3.1 HDMI to RJ45.

LAN to HDMI receiver RX*1pcs
User's manual*1pcs
① DC5V power input
② HDMI signal input
③ RESET
④ RJ45 signal output
⑤ HDMI signal indicator led. It lights on all the time with HDMI signal
input,flashes with no signal input.

3.2 RJ45 to HDMI

① Network cable length adjust button, There are total 12 levels and can be
switched cycilically. Supports memory function and needs no setting after
power off.
② RJ45 signal input
③ The first level network cable length LED,if you need the third level
network cable length,please press the button"LENGTH"twice when this
LED lights on and so on.
④ Connection status indicator led. It lights on all the time with HDMI signal
transmission,flashes with no signal transmission.
⑤ DC5V power input
⑥HDMI signal output