Whirlpool AKZ9S 8270 FB Owner's Manual page 4

• SMART CLEAN
The action of the steam released during this
special low-temperature cleaning cycle allows
dirt and food residues to be removed with ease.
Pour 200 ml of drinking water on the bottom of
the oven and only activate the function when the
oven is cold.
SETTINGS
For adjusting the oven settings.
When "ECO" mode is active the brightness of the display
will be reduced to save energy and lamp switches off after
1 minute. It will be reactivated automatically whenever any
FIRST TIME USE
1. SELECT THE LANGUAGE
You will need to set the language and the time
when you switch on the appliance for the first time:
"English" will show on the display.
English
Press or to scroll through the list of available
languages and select the one you require.
Press to confirm your selection.
Please note: The language can subsequently be changed
by selecting "LANGUAGE" in "SETTINGS" menu, available by
pressing .
2. SET THE POWER CONSUMPTION
The oven is programmed to consume a level of
electrical power that is compatible with a domestic
network that has a rating of more than 3 kW (16): If
your household uses a lower power, you will need to
decrease this value (13).
POWER
Press or to select 16 "High" or 13 "Low" and press
to confirm.
3. SET THE TIME
After selecting the power, you will need to set the
current time: The two digits for the hour will flash on
the display.
CLOCK
Press or to set the current hour and press
two digits for the minutes will flash on the display.
Press or to set the minutes and press
confirm.
Please note: You may need to set the time again following
lengthy power outages. Select "CLOCK" in "SETTINGS"
menu, available by pressing
: The
to
.
of the buttons are pressed.When "DEMO" is "On" all
commands are active and menus available but the oven
doesn't heat up. To deactivate this mode, access "DEMO"
from "SETTINGS" menu and select "Off".
By selecting "FACTORY RESET", the product switches off and
then it returns to first switch on. All settings will be deleted.
FAVORITES
For retrieving the list of 10 favorite functions.
4. SET THE WATER HARDNESS LEVEL
In order to allow the oven to work efficiently, and
to guarantee that it regularly prompts the user to
perform Descale cycle when needed, it is important
to set the correct water hardness level. To set it, switch
on the oven by pressing
use navigation buttons
HARDNESS". Press to confirm. Use navigation
buttons and to select the correct level for the
water of your area, based on the following table:
WATER HARDNESS LEVELS TABLE
°dH
Level
German
degrees
1 Very soft 0-6
2 Soft 7-11
3 Mid 12-16
4 Hard 17-34
5 Very hard 35-50
Press to confirm.
For Water Hardness level, "Hard" is preset.
5. HEAT THE OVEN
A new oven may release odours that have been left
behind during manufacturing: this is completely
normal.
Before starting to cook food, we therefore
recommend heating the oven with it empty in
order to remove any possible odours. Remove any
protective cardboard or transparent film from the
oven and remove any accessories from inside it. Heat
the oven to 200 °C for around one hour, ideally using
a function with air circulation (e.g. "Forced Air" or
"Convection Bake").
Please note: It is advisable to air the room after using the
appliance for the first time.
, press Settings and
and to select "WATER
°fH °Clark
French English
degrees degrees
0-10 0-7
11-20 8-14
21-29 15-20
30-60 21-42
61-90 43-62