Advertisement
Code
Type
T
(cont.)
Transparency
Check
U
Printer
Printer Error
Received Data
Block
Inquiry Error
Mode
E.u.v.x
E,X
COMM
1
P,U,X
P,U,X
P,U,X
COMM
1
COMM
1
Causes
• Pressed RIGHT ADJ at the end of
the record.
• Pressed DISPLAY PROD STAT in
Enter mode with record length in
data set label less than 21.
• BSCA control characters are re-
corded on the disk.
• Printer has run out of forms.
• Left margin stop moved too far
to the right (3713 printer).
• Illegal character (a nondisplayable
character) was encountered.
• 3715 Printer power switch is off.
• You and the remote location are
both trying to transmit data.
• A conversational or text reply was
received in response to the trans-
mission of the operator ID card data.
1
COMM identifies errors that occur during communications; see Communications.
What You Do
Reset, advance to the next record or
backspace to the field within the record.
Reset and display statistics in Index mode
or change the record length in the data
set label.
Select the appropriate transparent mode
(P or D) and re-establish the connection.
Reset and check forms.
Turn off the power, wait five seconds,
and turn the power back on.
Press REC ADV to continue printing or
press RESET twice to exit the printer
mode. (See the
IBM 3741 Data Station
Reference Manual.
GA21-9183. for more
information on correcting printer
errors.)
Turn the 3715 power switch on and press
RESET.
After selecting compatible modes, re-
establish the connection.
Call the remote location and have them
correct the problem. Restart communi-
cations.
245
Advertisement
