Guide to Performing Routine Maintenance
Perform this task only when the fuser is cool. Exercise care
to prevent burns when working in this area. Do not perform
this task if the fuser is hot.
4. Determine if the fuser is cool.
Place your hand approximately 1 inch (25 mm) above the
fuser area.
If you feel heat, STOP, leave the fuser drawer out, and wait
for the fuser to cool. DO NOT touch the fuser while it is hot.
If you DO NOT feel heat, continue with the procedure.
Fuser lubricant contains silicone that causes eye irritation
upon contact. Wash your hands with soap and water after
you finish this procedure.
5. Put on gloves.
Fuser lubricant and pressure roll wiper
WARNING
WARNING
4-7