Table of Contents
Advertisement
38
en | Installing the drive trays for the E2700 controller-drive tray configurations
To install drives in the DE1600 drive tray:
1.
2.
3.
4.
8.4
Procedure – installing the DE6600 drive tray
You can install the high-density, 6-Gb SAS SBB 2.0-compliant DE6600 drive tray into an
Industry-standard cabinet, provided it has a depth of 100 cm (40 in.).
A minimum depth of 76 cm (30 in.) between the front EIA support rails and the rear EIA
support rails is required.
Warning!
Risk of bodily injury
!
Three persons are required to safely lift the component.
Warning!
Risk of bodily injury
!
An empty tray weighs approximately 56.7 kg (125 lb). Three persons are required to safely
move an empty tray. If the tray is populated with components, a mechanized lift is required to
safely move the tray.
2016.12 | V2.1 | DOC
Beginning with first drive slot in the upper-left side of the DE1600 drive tray, place the
drive on the slot guides, and slide the drive all the way into the slot.
Push the drive handle to the right to lock the drive securely in place.
Note: In some models, the drive handle might have the hinge on the right.
1
1 - Drive handle
Install the second drive beneath the first drive.
Install the other drives from top to bottom and then from left to right.
Installation manual
DSA E-Series (E2700)
97006-01
Bosch Sicherheitssysteme GmbH
Advertisement
Table of Contents
