Bosch DSA-N2E7X2-08AT Installation Manual page 35

DSA E-Series (E2700)
5.
Bosch Sicherheitssysteme GmbH
Installing the drive trays for the E2700 controller-drive tray configurations | en
3
2.
3
1.
4
1 - Mounting rail
2 - Existing tray
3 - Clearance above and below the existing tray
4 - Screws for securing the mounting rail to the cabinet (front and rear)
5 - Industry standard cabinet
Note: Risk of equipment malfunction - To avoid exceeding the functional and
environmental limits, install only drives that have been provided or approved by the
original manufacturer. Not all controller-drive trays or drive trays are shipped with pre-
populated drives. System integrators, resellers, system administrators, or users of the
controller-drive tray or drive tray can install the drives.
Attach the mounting rails to the cabinet.
– Make sure that the adjustment screws on the mounting rail are loose so that the
mounting rail can extend or contract as needed.
1
3
1 - Cabinet mounting holes
2 - Adjustment screws for locking the mounting rail length
3 - Mounting rails
4 - Clip for securing the rear of the controller-drive tray
– Place the mounting rail inside the cabinet, and extend the mounting rail until the
flanges on the mounting rail touch the inside of the cabinet.
– Make sure that the alignment spacers on the front flange of the mounting rail fit into
the mounting holes in the cabinet.
1
2
5
78039-02
2
4
78039-03
Installation manual
4
2.
1.
1
35
2016.12 | V2.1 | DOC