Electronic Controls Set-Up Instructions (Pd Models) - Maytag MAT23CS Instructions Manual

Install a lock and cam on the meter case service door. Install
the coin vault with lock and key in the meter case opening.
For Free Vend, an OPL kit can be purchased from Whirlpool.
Whirlpool part number W10222023.
ELECTRONIC CONTROLS SET-UP
INSTRUCTIONS
Basic Operation of Commercial Washer
For additional information, see
■
www.maytagcommerciallaundry.com.
IMPORTANT
Electrostatic Discharge (ESD)
Sensitive Electronics
ESD problems are present everywhere. ESD may damage
or weaken the electronic control assembly. The new control
assembly may appear to work well after repair is finished, but
failure may occur at a later date due to ESD stress.
Use an anti-static wrist strap. Connect wrist strap to green
■
ground connection point or unpainted metal in the washer.
Touch your finger repeatedly to a green earth connection
point or unpainted metal in the washer.
Before removing the part from its package, touch the
■
anti-static bag to a green earth connection point or
unpainted metal in the washer.
Avoid touching electronic parts or terminal contacts; handle
■
electronic control assembly by edges only.
When repackaging failed electronic control assembly in
■
anti-static bag, observe above instructions.
16
Earthing
Earthing
connection
connection
(PD MODELS)
-OR-
GENERAL INFORMATION
Blank Display
This condition indicates the washer is inoperative.
"0 Minutes" showing in display
This condition indicates the washer cannot be operated. Coins
dropped or debit inputs during this condition will be stored in
escrow but cannot be used until normal operation is restored by
opening and closing the door. If a door switch fails, it must be
replaced before normal operation can be restored.
Cold Start (initial use)
Washer is programmed at the factory as follows:
POWERWASH = 12 minutes agitation
■
NORMAL = 9 minutes agitation
DELICATES = 6 minutes agitation
NORMAL ECO = 8 minutes agitation
NORMAL = 1 rinse and 2 minutes of rinse agitation
■
POWERWASH = 1 deep rinse with spin-out
DELICATES = 1 deep rinse with spin-out
NORMAL ECO = 1 spray rinse
NORMAL = $2.00
■
DELICATES = $1.75
POWERWASH = $2.50
NORMAL ECO = $1.75
Warm Start (after power failure)
After a delay of up to 8 seconds, the washer is restored to
the portion of the cycle that existed at time of the power failure.
To continue the cycle, press START/PAUSE.
Free Cycles
This is established by setting the cycle price to zero. When this
happens, "SELECT CYCLE" will appear and cycle price will show
"0.00."
Display
After the washer has been installed and plugged in, the display
will show "SYNC" for a few seconds, then "0 MINUTES." Once
the washer has been plugged in and the washer lid opened and
closed, the display will show the price. In washers set for free
cycles, the display will flash "SELECT CYCLE," and will display
"PRICE 0.00."
CYCLES
POWERWASH
NORMAL
DELICATES
NORMAL
ECO
Pausing/Stopping a Cycle
To pause/stop a wash cycle, hold the START/PAUSE button for
approximately 2 seconds untill the machine enters the
pause/stop state on the display. As safety protocols are met, the
user will gain access to the basket. The door must be closed and
a separate action of pressing the START/PAUSE button again will
be necessary to unpause and complete the cycle.
OPTIONS
TEMPERATURE
SOIL LEVEL
EXTRA RINSE