Maytag MAT23CS Instructions Manual page 11

1. The appliance shall be disconnected from the power supply
before servicing. Read all instructions before any disassembly.
2. Remove retaining screw securing power cord assembly to the
product and save for re-installation.
Retaining
Screw
3. Rotate the power cord strain relief bracket within the machine
console and remove at an angle from the opening in the back
panel to expose access to the inner connector. The inner
connector is still connected. Do not put strain on the conductors
while removing the bracket to allow access to the connector.
Twist
Remove at
Angle
Outside Product
4. Disengage the supply connection within the product by
depressing the connector clip to release the power cord from
the appliance.
Press
5. Remove the U-Clip from the strain relief bracket by sliding
downward and save for re-installation.
U-Clip
Inside Product
6. Remove the cord from the strain relief bracket and follow the
cord installation steps 7-12. Save the strain relief bracket for
re-installation.
Power Cord
7. Select the regionally required cord/plug and slot it through the
strain relief bracket.
8. Ensure that the molded strain relief of the power cord is
aligned and inserted all the way into the strain relief bracket
before installing the U-Clip. Once inserted, install the U-Clip
to lock the molded on strain relief of the power cord in
position within the strain relief bracket.
U-Clip
9. Insert the cord into the machine and secure the cord side
connector to the matching machine side connector. Ensure
the connector lock is engaged.
Strain Relief
Bracket
Power cord
Molded
on Strain
Relief
Align Molded
on Strain
Relief with the
Strain Relief
Bracket Key
11