Electronic Controls Set-Up Instructions - Maytag MVW18MNBGW Installation Instructions Manual

ELECTRONIC CONTROLS SET-UP INSTRUCTIONS

Basic Operation of Commercial Washer
For additional information, see
n
www.MaytagCommercialLaundry.com
IMPORTANT
Electrostatic Discharge (ESD)
Sensitive Electronics
ESD problems are present everywhere. ESD may damage
or weaken the electronic control assembly. The new control
assembly may appear to work well after repair is finished, but
failure may occur at a later date due to ESD stress.
Use an anti-static wrist strap. Connect wrist strap to green
n
ground connection point or unpainted metal in the washer.
Touch your finger repeatedly to a green earth connection point
or unpainted metal in the washer.
Before removing the part from its package, touch the
n
anti-static bag to a green earth connection point or
unpainted metal in the washer.
Avoid touching electronic parts or terminal contacts; handle
n
electronic control assembly by edges only.
When repackaging failed electronic control assembly in
n
anti-static bag, observe above instructions.
GENERAL USER INFORMATION
Blank Display
This condition indicates the washer is inoperative.
'0 Minutes' showing in display
This condition indicates the washer cannot be operated. Coins
dropped or debit inputs during this condition will be stored in
escrow but cannot be used until normal operation is restored by
opening and closing the door. If a door switch fails, it must be
replaced before normal operation can be restored.
Cold Start (initial first use)
Washer is programmed at the factory as follows:
POWER WASH = 19 min agitation
n
NORMAL = 9 min agitation
DELICATES = 7 min agitation
NORMAL = 1 rinse and 2 minutes of rinse agitation
n
POWER WASH = 4 spray rinses with spin-outs
DELICATES = 3 spray rinses with spin-outs
NORMAL = $1.50
n
DELICATES = $1.00
POWER WASH = $2.00
16
-OR-
Warm Start (after power failure)
After a delay of up to 8 seconds, the washer is restored to the
portion of the cycle that existed at time of the power failure. To
continue the cycle, press START.
Free Cycles
This is established by setting the cycle price to zero. When this
happens, 'SELECT CYCLE' will appear and cycle price will show
0.00.
Display
After the washer has been installed and plugged in, the display
will show 'SYnC' for a few seconds, then '0 MINUTES'. Once
the washer has been plugged in and the washer lid opened and
closed, the display will show the price. In washers set for free
cycles, the display will flash 'SELECT CYCLE', and will display
'PRICE 0.00'.