Advertisement
Fasten vise leadscrew plate to benchtop with
5.
(4) M6 x 30 tap screws (see Figure 6).
Figure 6. Attaching vise leadscrew plate to
benchtop.
Place benchtop on legs and attach with (4)
6.
M8 x 80 lag bolts and 8mm flat washers (see
Figure 7).
Figure 7. Fastening benchtop to frame.
Feed vise leadscrew assembly through vise
7.
head and attach with (4) M6 x 30 tap screws
(see Figure 8).
x 4
Figure 8. Assembling vise components.
Model T34092 (Mfd. 11/23)
x 4
x 4
Thread vise assembly through leadscrew
8.
plate and tighten until vise head makes con-
tact with workbench (see Figure 9).
Thread (2) M8-1.25 x 16 hex bolts and (2)
9.
8mm fender washers into back of vise rods
(see Figure 9).
Figure 9. Installing vise assembly.
10. Completed vise installation should resemble
Figure 10. Test vise range of motion by turn-
ing handle counterclockwise to open and
clockwise to close.
Figure 10. Vise assembly installed.
x 4
-3-
Advertisement
