Thank you for choosing FUNN's FLAME ON/FLAME PG handlebar for your mountain bike.
Please read these instructions thoroughly before attempting to install this item.
Following all fitting instructions in order is required for compliance with FUNN's warranty policy.
tools required
. Hex keys
contents
. FLAME ON/FLAME PG Handlebar
HANDLEBAR CUTTING
FUNN handlebars are designed to be cut down to fit your style, but when trimming carbon bars, special care is required, so
it's best to consult a professional.
For precise adjustments, follow the guide marks on the bar,
ensuring you don't cut below the inner-most mark for safety.
It's important to cut the same distance on both sides to
maintain balance. Remember, after cutting carbon bars, refrain
from using bar ends to ensure the integrity of your handlebars.
Handlebar installation
1.
Carefully detach any components attached to the old handlebars, such as shifters, brake levers, grips, and bar ends.
2.
Loosen and then remove the stem faceplate. Following this,
remove the old handlebars from the stem.
WWW.FUNNMTB.COM
FLAME ON/FLAME PG HANDLEBAR 2024.01.30 / REV. 0
FLAME ON/FLAME PG HANDLEBAR
1 PC
INSTALLATION AND USE
Need help?
Do you have a question about the FLAME ON/FLAME PG HANDLEBAR and is the answer not in the manual?
Questions and answers