Table of Contents
Advertisement
The LED indicator turns on.
9.1
Using the Advanced Lithium app
1.
Download the Go Power Connect! app.
2. Add a device for the GP-ADV-Lithium battery.
3. Setup one master battery by pressing and then configure each individual battery.
4. Press
to blink the power LED for physical reference of the current bat-
Indicate
tery configured.
5. Press
for each individual battery to configure it.
Setup
6. Press
when each battery is configured. Changing the DC Instance
Load System
will change all the batteries to match for the battery bank.
7.
Set the battery instance configuration through the change battery instance (mas-
ter/secondary).
a) Set the battery instance to assign different instances for each battery.
b) Batteries in series must have the same series string value. Batteries wired in par-
allel must be different from each other.
c) There must be only one master per DC source. All other batteries on the DC
source must be in secondary.
8. Press
system to run the main functionalities.
Load
9.
Monitor the battery voltage, DC current, power, Ah remaining, time remaining,
charge state, and battery temperature.
9.2
Charging
WARNING! Damage Hazard
• Do not hot-swap the battery pack connection unless necessary, it will
cause surge current.
• Do not charge with higher current than recommended value. It will
damage the battery electrical, mechanical and safety performance and
could lead to heat generation or leakage.
Charging current should be less than maximum charging current.
Charging voltage should be less than 14.6 V. Charging beyond this absolute
maximum voltage is strictly prohibited.
The battery should be charged within the charging temperature range.
Reverse charging is prohibited.
The battery should be connected correctly and the polarity should be confirmed
to be correct before wiring.
In case the battery is connected improperly, the battery cannot be charged.
The reverse charging may cause damage to the battery which may lead to degra-
dation of battery performance and safety, and could cause heat generation or
leakage.
EN
7
Advertisement
Table of Contents
