Customizing settings
Accessing programming mode
The sensor control is located ap-
prox. 1/2" (1 cm) (index finger width) to
the left of the sensor control.
The cooktop is switched off.
Touch and hold the and sensor
controls until the sensor control
lights up and appears in the timer
display.
After a few seconds : (Program 01)
will flash alternately with : (Code) in
the timer display.
54
Setting the program
For a two-digit program number you
first need to set the tens position.
While the program is visible in the
display (e.g., :), touch the sen-
sor control repeatedly until the num-
ber for the program you want appears
in the display or touch the appropri-
ate number on the numerical display.
Setting the code
While the code is visible in the display
(e.g., :), touch the sensor con-
trol repeatedly until the number for
the code you want appears in the dis-
play or touch the appropriate number
on the numerical display.
Saving the settings
While the program is visible in the
display (e.g., :), touch the sen-
sor control until the indicators go out.
To avoid saving the settings
While the code is showing in the dis-
play (e.g., :), touch the sensor
control until the indicators go out.