Booklet Maker; Tray Alignment - Xerox 4127 Customer Release Notes

Booklet Maker

Tray Alignment

Booklet Maker documentation
There is no online help specific to Booklet Maker. For information about this feature,
see the Booklet Maker chapter in Print Options on the user documentation CD.
Booklet Maker on Direct queue
When you send a job to the Direct queue, Booklet Maker is not supported, although it is
displayed as enabled. You can send a Booklet Maker job to the Print or Hold queue.
Setting gutter values
The gutter value for a booklet in Booklet Maker cannot be set from the printer driver.
Set the gutter value in Command WorkStation Job Properties.
Selecting a binding method in Mac OS X printer driver
In Booklet Maker, you cannot select Saddle, Perfect, or Nested Saddle binding in the
Mac OS X printer driver, if the printer driver has been installed in Comprehensive
(Constrained) mode. To make these options available, install the Mac OS X printer driver
in Fast (Unconstrained) mode.
Unwanted constraint
If Booklet Maker is enabled, selecting Booklet Fold or Center Stapling in the Finishing
tab of the printer driver with page or print size set to Letter LEF triggers a constraint message.
Select a different print size with valid SEF in Media Tab to resolve constraint.
Align Trays
The Align Trays feature allows you to adjust the placement of text and images on the
page so they are correctly aligned on a sheet of paper. This ensures that both sides of a duplex
sheet have exactly the same alignment. You can also perform tray alignment from the
Fiery EX4112/4127 Control Panel.
To perform tray alignment, you must do the following:
• Log in to the Fiery EX4112/4127 with Administrator privileges and enable tray alignment
in Fiery EX4112/4127 Setup.
• Enable Tray Alignment in the Media area of the Fiery EX4112/4127 printer driver.
• Select the correct paper tray before printing.
For Tray Alignment to work when printing a job, select the tray that you have
N :
OTE
aligned in the Media area before printing. If you later print a job using the auto tray selection,
the alignment does not work.
Page 2