Using The Emergency Crank; Operating With A Somfy Sun Sensor; Operating With A Somfy Wind Sensor; Additional Settings - SOMFY Sunea CMO RTS Instructions Manual

EN

3.4. USING THE EMERGENCY CRANK

Never use the emergency crank if a RTS control point is
not programmed in the motor.
Do not lower the awning below the arm breakage point
with the crank.
Check that the mains power supply is off.
-
Hook the Somfy emergency crank into the eye outlet.
-
Turn the crank to raise or lower the awning.
-

3.5. OPERATING WITH A SOMFY SUN SENSOR

Refer to the corresponding guide.

3.6. OPERATING WITH A SOMFY WIND SENSOR

Refer to the corresponding guide.
3.6.1. Behavior when the wind rising
When the wind rising, the awning moves to the upper end limit. However, It is impossible to prevent
awning from being raised and lowered when the wind is blowing at speeds above the threshold set.
3.6.3. Behavior when the wind dropping
When the wind dropping, a manual lowering command can be sent by the RTS control point after
30 seconds. However, all automated systems will still remain locked for 12 min.

3.7. ADDITIONAL SETTINGS

3.7.1. Modifying the favourite position (my)
Place the motorised product in the desired favourite
1)
position (my).
Press my
2)
up and down: the desired favourite position (my) has been
programmed.
3.7.2. Deleting the favourite position (my)
1) Press my: the motorised product starts to move, and stops
in the favourite position (my).
2) Press my again until the motorised product moves: the
favourite position (my) is deleted.
3.7.3. Adding/Deleting Somfy control points and sensors
Refer to the corresponding guide.

3.8. OPERATION AFTER A SINGLE POWER OUTAGE

less than 2 mins. For longer power outages, the motor switches to a mode for resetting the end limit.
To return to standard operating mode, carry out one of the following 3 operations.
22
motorised product moves
Copyright 2009 - 2017 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
©
OFF
1 2
or
my
1 2
my
Sunea CMO RTS