SOMFY Sunea RTS CMO Reference Manual

Sunea® RTS CMO Visual Reference Guide
Connect motor to power. If programming multiple motors, power one motor at the time.
NOTE: In Programming Mode, the shade operates in momentary fashion. Motor will exit programming mode after 2 minutes of inactivity.
SETTING FOR STANDARD AWNING: MANUAL UP AND DOWN LIMITS
Step 1:
Initiate programming by pressing
both the UP and DOWN buttons at
the same time until the motor jogs.
(A jog is a brief in and out motion)
Step 3:
Bring the awning to your desired
upper limit. Press & hold both the MY/
STOP and DOWN buttons until the awning
begins to extend, then release. Stop at the
desired lower limit, adjust by pressing the
UP or DOWN buttons.
SETTING FOR CASSETTE AWNING: AUTOMATIC UP LIMIT
Step 1:
Initiate programming by pressing
both the UP and DOWN buttons at the
same time until the motor jogs.
(A jog is a brief in and out motion)
Step 3:
Bring the awning to your
desired lower limit. Press & hold
both MY/STOP and UP
buttons until the awning begins to
retract, then release.
Please contact Somfy for detailed installation instructions at www.somfysystems.com or call 800-22-SOMFY
Copyright © Somfy SAS 3/2019
Step 2:
Check the direction of operation.
Press the DOWN button and confirm the
awning extends.
Step 4:
Press & hold the UP
and MY/STOP buttons until the
awnings begins to retract. The
motor will stop at the original
upper limit. Adjust if necessary.
Step 2:
Check the direction of operation.
Press the DOWN button and confirm the
awning extends.

Step 4:
Press the MY/STOP
button and stop the awning
halfway.
P-0037
If the awning closes, change the direction by pressing & holding the
MY/STOP button until the motor jogs. Confirm correct direction of
operation before proceeding.

Step 5:
Press & hold the
MY/STOP button until the
motor jogs to confirm the
limit setting.
If the awning retracts, change the direction by pressing & holding the
MY/STOP button until the motor jogs. Confirm before proceeding.
Step 5:
Press & hold the MY/STOP
button until the motor jogs
confirming the limit settings. The
motor will then automatically set its
inner limit.
Step 6:
To finalize briefly press the
PROGRAMMING BUTTON on the back of
the transmitter. The motor will jog confirming
limit settings and is now in User Mode.
Double check limits as a precaution.
Programming
Button
Step 6:
To finalize briefly press the
PROGRAMMING BUTTON on the back of
the transmitter. The motor will jog confirming
limit settings and is now in User Mode.
Double check limits as a precaution.
Programming
Button

