Maintenance And Storage; Additional Safety Instructions For Devices With Collecting Containers; Package Contents; Operating Instructions - PrimAster PMWH 3000 Operating Instructions Manual

and other build-up to avoid damage and po-
tential risk of fire. Remember that the blades
continue to operate after the machine is shut
down.
• Keep all protection and shielding equipment in
good condition.
• Do not tinker with the motor controller settings.
The controller regulates the safe maximum
speed and protects the motor and all mov-
ing parts from damages caused by excessive
speeds. In the event of an issue, seek out spe-
cialised help.
• Always shut down the shredder (power unit
must be disconnected from the mains) when
you leave the work area.
• Do not tilt the machine when the motor is run-
ning.

3.3 Maintenance and Storage

• If the machine is deactivated for maintenance,
inspection, storage, or for exchanging a part,
(power unit must be disconnected from the
mains), ensure that all moving parts are still
and any tools/spanners have been removed.
Let the machine cool before any inspection or
repair.
• When maintaining the blade mechanism,
make sure that the the power source cannot
activate due to the protective locking device;
the blades could always be activated by a
hand-start mechanism.
3.4 Additional Safety Instructions for Devices
with Collecting Containers
• Shut down the shredder before attaching or
removing the collecting container.

4. Package Contents

• Remove the packaging material.
• Remove the packaging and/or transportation protec-
tion (if present).
• Verify that the delivery is complete.
• Check the unit and accessories for transportation
damage.
• If possible, store the packaging until the end of the
warranty period. After that period, please dispose of
the packaging in an environmentally friendly manner.
WARNING: The packaging material is not a play
toy! Please keep plastic bags out of the reach of
children. There is a risk of choking.
1x Garden Shredder
2x Wheel set
2x Support foot set
1x Collection box
GB | Operating Instructions
1x Base frame
1x Small parts bag
1x Adjusting knob
1x Spanner
1x Instruction manual

5. Operating Instructions

After unpacking and inspecting the shredder for damage,
proceed with the following steps:

5.1 Assembling the Garden Shredder

• Turn the shredder over.
• Fold both legs up and insert the supplied axle through
• Place both washers on the left and ride side of the axle
• Place the supplied threaded spacer on the axle. Then
5.2 Collecting Container (Abb. 4)
• Slide the collection box back to the base frame. En-
• Lock the collection box with safety switch in position by
Emptying the collection box
The level of shredded material debris in the collection box
can be checked by looking through the notches on the
upper face of the base frame. Always empty the collection
box in good time to prevent it from overfilling.
To empty it, proceed as follows:
a) Switch off the device at the ON/OFF switch.
b) Press the safety switch down (fig. 4).
c) Release the collection box. Take the collection box out

6. Operation

6.1 On/off switch (Abb. 5)
• Press the green button (3) to switch on the shredder.
• Press the red button (3) to switch it off
6.2 Reversing switch (Abb. 6)
GB-5
If parts are missing or damaged, contact your
dealer.
WARNING: You may need help unpacking and
assembling the machine.
the openings (fig. 2).
(fig. 3).
attach the wheels and finally the safety nuts with the
wheel covers.
WARNING: Be careful when leaning the device
on the wheels, since the weight is unbalanced
when titled and moved.
sure that the collection box runs above the guide rails.
pushing upwards. .
.. . .
at the front.
Note: This machine is equipped with an elec-
tromagnetic switch to prevent it from being
unexpectedly switched on when power source
recovered.
This shredder has an automatic overload pro-
tection and reverse switch.
A sudden blocking the device automatically (3 sec.)