Table of Contents
Advertisement
Accessory Installation Guide C- 7
15. Slide drive into unit from the front. While drive is still protruding about 1 inch, attach
the flat cable connector at
J3
(see Figure C-5).
16. Slide the drive in the rest of the way.
17. Re-install the two screws removed in step 10, with washers, in the side of the unit.
CAUTION
MAKE SURE THE SCREW IN THE SLOTTED HOLE HAS A
WASHER ON IT.
18. Install the two furnished half-inch screws, with washers, in the bottom (see Figure
C-5).
CAUTION
MAKE SURE THAT THE FURNISHED HALF-INCH SCREWS
GO IN THE BOTTOM, AND THE THREE-EIGHTHS-INCH
SCREWS REMOVED IN STEP 13 GO IN THE SIDE. REVERS-
ING THESE SCREWS WILL CAUSE IMPAIRED PERFOR-
MANCE AND DAMAGE TO THE DRIVE.
19. Attach the ac and de connectors at the rear of the drive (see Figure C-6).
20. For Option 11 units, go to step 25.
21. Slide the controller board into the unit from the front, component side up. Be sure the
flat, gray cable stays above the controller board with the connector out the front of the
unit.
22. Point the board extractor (see Figure C-2), at either front corner of the controller
board, straight out and then push the controller board as far into the unit as possible.
Push the extractors flat against the controller board, thus seating the controller board
the rest of the way into the unit.
23. Attach the connector on the gray, flat cable onto the edge connector on the right, front
side of the controller board.
24. Install the retainer for the HP-IB connector just attached, as shown in Figure C-5.
25. Replace the bottom cover onto the unit.
26. Place the unit on a broad, flat object and slide the cover onto the unit.
27. Secure the case to the unit with the screws previously removed from each of the
lower, rear corners of the unit.
28. Re-install the screws previously removed from the front panel recessed positions (see
Figure C-2).
29. Re-connect the power cord to the unit.
30. For Option 11 units (without controller), connect the unit to the 9895A via the slave
cable (09895-61606). Remove the front panel of the 9895A and conduct the follow-
ing steps on the 9895A to check out the 9895 Option 11.
Advertisement
Table of Contents
