Splitter Type C4S - darda C2S Product Manual

6
6.1
6.1.1
OM Hydraulic Stone and Concrete Splitter, Version 1.0 04/2010
Replacing Splitting Heads
We call your attention expressly to the fact that the conversion and the hy-
draulic installation of the device may only be carried out by trained and
authorised personnel with a profound mechanical and hydraulic knowledge!

Splitter Type C4S

Expansion of the splitting wedge and / or pressure pieces
A
1 Sickle spanner
2 Rubber disc
3 Grommet nut
4 Splitting wedge
5 Rubber disc
Fig. 6-1-1 - 1 Expansion of the splitting wedge / pressure pieces
Retract the splitting wedge (4) completely (operating lever in position R).
Pull the rubber disc (2) forward.
Remove the grommet nuts (3) with the sickle spanner (1) (fig. A).
Remove the guide disc (6) and the inner rubber disc (5) with a screwdriver
(fig. B).
Extend the splitting wedge completely (operating lever in position F).
Switch off the hydraulic aggregate and protect it against accidental start-
up!
Remove the screw (7) and the plastic cap (9) on the opposite side.
Hit the bolt (8) with a mandrel and a hammer out of the wedge head (fig. C).
Pull the splitting wedge out of the splitting cylinder.
Remove the pressure pieces (10), if need be, by turning them 90º and
pulling them out.
6 Replacing Splitting Heads
B C
6 Guide disc
7 Screw
8 Bolt
9 Plastic cap
10 Pressure piece
29