Table of Contents
Advertisement
4. Installation
1. Connect the wheel fixation pedestal ② and the rear wheels ③ to the pedestal ①.
2. Fix the column ④ on the pedestal ①.
Do not push the lever with ball knob ⑤, otherwise arm can move up and cause in-
3. Mount the emitter group 18 directly to the box of the arm 17.
4. Attach the power wires (A-F and distance sensor) into the associated sockets at the junction
box.
5. Remove the sticker from the protection cover.
6. Remove the red foam cubes behind the tube.
Notes:
•
Living core (brown), neutral wire (blue), earth wire (green/yellow).
•
Power supply: 16 A, 3 PH, 400V/50Hz.
•
The device has to be protected by a 16-Ampere-fuse. A fuse with characteristic C for high start-
ing currents is recommended.
•
When moving the emitter group up and down, use one hand to hold the Cross arm on the
handhold and push the pneumatic handle with ball knob 11 with the other hand.
– Technical changes and errors reserved. All pictures similar –
IR-B06 / IR-B06-T
jury. Do not twist the ball knob to avoid malfunction.
Move the cross arm only by using the handle, otherwise risk of injury!
Page 7
Advertisement
Table of Contents
