Table of Contents
Advertisement
5. Operating Instructions
Notes:
•
Power supply: 1PH 230V 50/60HZ
•
Do not touch the lens cap during and after curing to avoid burns.
(1) Time display
(2) Memory function
(3) Start/Stop emitter cassette
(4) Start/Stop emitter cassette
(5) Start/Stop emitter cassette
(6) Timer for pre-curing (Flashlight)
(7) Timer for full-curing (Continuous)
(8) Ultrasonic distance control
(9) Pause (1x for pause, 2x for stopping)
When the device is working or paused, buttons (2), (6) & (7) are disabled and will
be reactivated when the working process is finished and/or device has stopped.
1. Choose the optimal distance between emitter and car body. The optimal
distance is approximately 50 cm. (If distance control is used, see instruc-
tions further below).
2. Use the lever with ball knob to adjust the emitters to the needed height.
3. Adjust the direction of the emitters. They emitter tubes have to be paral-
lel to the car body.
4. Tighten the toggles and activate the brakes of the rear wheels to avoid
any accident due to unintended movements of the device.
5. Turn on the power switch (11).
6. Set pre-curing (Flashlight) time (6). Depending on material choose between 1 - 35 minutes.
Default setting is 15 minutes. Set to 0 minutes, if no pre-curing required.
7. Set full-curing (Continuous) time (7). Depending on material choose between 1 - 35 minutes.
Default setting is 15 minutes. Set to 0 minutes, if no full-curing required.
8. Activate the ultrasonic distance control (8) and find the optimal distance. The optimal distance
is indicated by the green indicator light of the sensor.
9. Point the laser on the part to be dried and set the temperature control as described in section
5.1 (Only IR-B06-T).
10. Choose emitter cassette(s) (3/4/5).
11. Press Start/Stop-button (10).
12. Press the pause button (9) once to pause the device and press Start/Stop-button to continue
curing. Press pause button (9) twice to shut down the emitter.
13. When the time is up, an acoustic signal occurs and the device shuts down.
IR-B06 / IR-B06-T
(10) Start/Stop
(11) Power switch
(12) Target temperature
(13) Temperature in °C
(14) Temperature display
(15) Actual temperature
(16) Temperature setting +/-
(17) Temperature in °F
3a
4a
5a
IR-B06-T
Page 8
3b
4b
5b
Advertisement
Table of Contents
