Table of Contents
Advertisement
6.1. Replacing Emitter Tube
Do not touch the reflector or the new IR tube with your fingers. Only remove the protective paper on
the IR tube when it's finally installed.
1. Loosen the screws on the side cover of the cassette and remove it.
2. Release heat dissipating plate.
3. Disconnect the cables of tube.
4. Remove the protective grid
5. Remove the old tube and replace it by a new tube.
6. Reassemble in reverse order.
Use a piece of soft cloth or cotton to clean the reflector plate and the tube with alcohol. Cleaning must
be done after the device is disconnected with the power and cooled down. Don't start the device until
the alcohol has evaporated, otherwise it may lead to ignition.
1
4
IR-B06 / IR-B06-T
Interrupt the power supply, before replacing
the infrared tube!
2
5
Disconnect
3
6
Page 11
Advertisement
Table of Contents
