1. Important Information We thank you for your trust you gave to us by purchasing this B-TEC device. On the type plate at your device you can find the exact type designation and serial-number of your infrared emitter to ensure an uncomplicated service and shipment of spare parts.
B-TEC warrants its products to be free from defects in materials and workmanship, for a period of 24 months on a one shift basis. In case of exceptional usage such as multiple-shift operation, the statutory warranty is shortened to 12 months (two-shift operation) or 8 months (three-shift operation). The period starts from the date the device is shipped from the factory.
Don’t misuse the electric wire. It is not allowed to drag the device with the power wire or pull the power plug. Please keep the power wire away from the hot, oily or sharp or movable objects. Please replace the damaged cables and wires as soon as possible for avoidance of electric shocks. IR-B06 / IR-B06-T Page 3...
1 - 35 min Temperature 60°C - 70°C Dimension (W x H x L) 1100 x 1250 x 1760 mm *Max. overall height with cassettes: 2400 mm Digital display Pneumatic-aided lifting Ultrasonic distance measurement Temperature control (Only IR-B06-T) IR-B06 / IR-B06-T Page 4...
11 with the other hand. Move the cross arm only by using the handle, otherwise risk of injury! – Technical changes and errors reserved. All pictures similar – IR-B06 / IR-B06-T Page 7...
9. Point the laser on the part to be dried and set the temperature control as described in section 5.1 (Only IR-B06-T). 10. Choose emitter cassette(s) (3/4/5). 11. Press Start/Stop-button (10).
5.1. Temperature Control (Only IR-B06-T) 1. Press Start key (15) and the temperature display (14) shows the actual temperature of the car body. 2. If you want to check the defined target temperature, press the button (12) and the tempera- ture display (14) shows the pre-set target temperature.
For replacing an emitter tube, ask the repair service center or a technician to do so. • If an emitter tube does not start working, it may result from a loose socket/cable. Switch off the device and check the sockets. IR-B06 / IR-B06-T Page 10...
Use a piece of soft cloth or cotton to clean the reflector plate and the tube with alcohol. Cleaning must be done after the device is disconnected with the power and cooled down. Don’t start the device until the alcohol has evaporated, otherwise it may lead to ignition. Disconnect IR-B06 / IR-B06-T Page 11...
Above specifications, drawings or diagrams are descriptive and subject to revision. If there are any discrepancies or changes, actual products shall prevail without otherwise notification. IR-B06 / IR-B06-T Page 12...