Table of Contents
Advertisement
4. Assembly / Installation
1. Insert the upper section ③ of the vertical bar into the lower section ②.
2. Take out the pedestal ①, insert the vertical bar into the pedestal ① and fasten the
screws.
3. Fit the lamp bracket ④ onto the vertical bar.
4. Attach infrared head (5) facing forward and tighten handle.
5. Attach the power wire.
6. Important: Remove the sticker from the protection cover.
7. Important: Take out the red foam cubes behind the tube.
Notes:
Power supply: 10Amp, 1 PH 110V/60Hz
When adjusting the height of lamp cap, use your left hand to support the lamp bracket
and your right hand to loosen the handle of the locking ring ④ for two turns, and then
move the bracket with two hands supporting the two ends of the lamp bracket. It is
best to use two hands to avoid any damage to the emitter / lamp.
8
Advertisement
Table of Contents
