Temperature Control (Only Ir-B06-T); Memory Function; Distance Control - B-TEC IR-B06 User Manual

5.1. Temperature Control (Only IR-B06-T)

1. Press Start key (15) and the temperature display (14) shows the actual temperature of the car
body.
2. If you want to check the defined target temperature, press the button (12) and the tempera-
ture display (14) shows the pre-set target temperature. The default temperature is 70°C
(150°F). When the object has reached the target temperature, the device pauses automatically
and will restart curing when the actual temperature has decreased and is lower than the target
value.
3. To adjust the target temperature, press button (12) and set the new target temperature with
+/- (16). Press button (12) again. The display switches off and the new target temperature has
been saved.
4. The new target temperature remains effective as long as the device is not shut down. After
the device is shut down, it will resume to the default value automatically.
5. Attention: Please keep the thermometer lens clean and dust-free! Close the dust-proof cover
when you don't use the temperature measuring function. If it is necessary to clean the lens,
open the front cover of the temperature measuring unit.
It´s recommended not to exceed a temperature of 70°C (150°F) when drying a part
made of plastic in order to avoid damages. In case of uncertainty please ask the
manufacturer of the part to be dried for information regarding heat resistance.

5.2. Memory Function

1. Set proper pre-curing and full-curing time according on the paint type.
2. Press and hold one of the four memory buttons for 4 seconds, the pre-curing and full-curing
time will be stored in this button. Four different settings can be stored.
3. When you need the stored setting, press the corresponding key.
4. To reset a memory button, repeat steps (1) & (2) to store new settings.

5.3. Distance Control

IR-B06 / IR-B06-T
1. Left red indicator: Distance is too far.
2. Left yellow indicator: Distance is rather
far.
3. Green indicator: Distance is suitable.
4. Right yellow indicator: Distance rather
close.
5. Right red indicator: Distance is too close.
Page 9