Cables - HP 30242 Installation And Service Manual

Installation
CABLES
Two cables are used to connect the LANIC to the MAD: an internal LANIC cable and the AUI cable.
The LANIC cable has a hood connector on one end and a female IS-pin D connector on the other. A
cabling diagram for the LANIC cable is shown in figure 2-2. The AUI cable uses a male IS-pin D
connector on one end and a female IS-pin D connector on the other. A cabling diagram for the AUI
cable is shown in figure 2-3.
P2
3D-PIN HOOD CONNECTOR
Pl
15-PIN D CONNECTOR
BLACK
BROWN
DRAIN WIRE
BLUE
ORANGE
FRAME GROUND
RED
WHITE
GREEN
YELLOW
Cl-A
ORANGE
Cl-B
YRLOW
VC (VOLTAGE COMMON) BLACK
DI-A BROWN
DI-B WHITE
VP
(VOLTAGE
PLUS)
RED
DO-A BLUE
DO-8
GREEN
.-..cl--t-- DRAIN WIRE
L...<l--11-
BRAID SHIELD
Pl
15-PIN
D
CONNECTOR
(FEMALE)
Figure 2-2. LANIC Cable Diagram
P2
1S-PIN D CONNECTOR
(~ALE)
BLACK
BROWN
DRAIN WIRE
BLUE
ORANGE
RED VP (VOLTAGE PLUS) RED
WHITE 01-8 WHITE
GREEN 00-8 GREEN
YELLOW CI-8 YELLOW
OVERALL BRAID SHIELD
(CONNECTED THROUGH METALLIZED SHELL)
Figure 2-3. AUI Cable Diagram
VC
(VOLTAGE
COMMON) BLA.CK
DI-A BROWN
DRAIN WIRE (INTERNAL SHIELD)
DO-A
8LUE
CI-A ORANGE
Feb 8S
2-3