Epson WF-M4119 Series User Manual page 188

Administrator Information
You can check the IP address of the printer from the following menu.
Settings > General Settings > Network Settings > Network Status > Wired LAN/Wi-Fi Status
2. Enter the administrator password to log in as an administrator.
3. Select in the following order.
Network tab >Wired LAN
4. Set each item.
❏ Link Speed & Duplex
Select the communication mode from the list.
❏ IEEE 802.3az
You can specify whether or not to enable IEEE 802.3az.
5. Click Next.
A confirmation message is displayed.
6. Click OK.
The printer is updated.
Configuring Wi-Fi Direct Settings
You can check or configure the Wi-Fi Direct Settings.
Note:
For models that support Wi-Fi, this item is displayed when the Wireless LAN Interface is installed.
1. Enter the printer's IP address into a browser to access Web Config.
Enter the printer's IP address from a computer that is connected to the same network as the printer.
You can check the IP address of the printer from the following menu.
Settings > General Settings > Network Settings > Network Status > Wired LAN/Wi-Fi Status
2. Enter the administrator password to log in as an administrator.
3. Select in the following order.
Network tab >Wi-Fi Direct
4. Sets each item.
❏ Wi-Fi Direct
You can specify whether or not to enable the Wi-Fi Direct.
❏ SSID
You can change the SSID (Network Name).whether or not to enable
❏ Password
When changing the Wi-fi Direct password, enter a new password.
❏ Frequency Range
Select the frequency range to be used in Wi-Fi Direct.
> >
Managing the Printer
188
Managing the Network Connection