GE TONOPORT V Operator's Manual page 16

Time and Date
Usually the BP monitors are set to the correct time and
date before delivery. Therefore, the time only needs to be
corrected to change between Standard Time and Daylight
Saving Time.
Setting Date and Time
 Briefly switch TONOPORT V off and on again and
wait for the time to be displayed.
INFO
 Push twice: the display indicates "H 2".
START
STOP
INFO
 Push : the display indicates the year, e.g.
START START
STOP STOP
"2009".
 If the indicated year is correct, confirm it with
INFO
or correct it with START
STOP
– The display indicates the month, e.g. "03".
 If the indicated month is correct, confirm it with
or correct it with INFO
START
STOP
 In the same manner, correct day, hour and minute.
 In the end, the time of day will be displayed again.
Selecting the Pressure Unit
 Briefly switch TONOPORT V off and on again and
wait for the time to be displayed.
INFO
 Push eight times: the display indicates "H 8".
START
STOP
INFO
 Push : the display indicates "mmHg" or "kPa".
START START
STOP STOP
 Confirm the pressure unit with
INFO
er unit with , then confirm with
START
STOP
16
INFO
START START
STOP STOP
and confirm with INFO .
START START
STOP STOP
INFO
START START
STOP STOP
and confirm with INFO .
START START
STOP STOP
INFO or select the oth-
START START
STOP STOP
.
INFO
START START
STOP STOP
TONOPORT V
Setup
Measurement Protocols
There is a choice of three different measurement
protocols:
Protocol Day Phase
(7 a.m. to 10 p.m.)
P1 every 15 minutes
P2 every 20 minutes
P3 every 30 minutes
Max. inflation pressure: day phase 250 mmHg
Select a Measurement Protocol
 Briefly switch TONOPORT V off and on again and
wait for the time to be displayed.
INFO
 Push three times: the display indicates "H 3".
START
STOP
 Push : the display indicates "LLLL" (Selecting
INFO
START START
STOP STOP
a protocol automatically clears the memory. If you do
not wish to clear the memory, turn the BP monitor
off.)
 Push : the display indicates "P1" (protocol 1).
INFO
START START
STOP STOP
INFO
 Using , select protocol 2 or 3
START
STOP
OR
 Confirm the displayed protocol with
Enable or Disable the Audio Signal
 Briefly switch TONOPORT V off and on again and
wait for the time to be displayed.
INFO
 Push seven times: the display indicates "H 7".
START
STOP
 Push : the display indicates "0000" when the au-
INFO
START START
STOP STOP
dio signal is turned off, and "1111" when it is turned
on.
 Either confirm the setting with
select the alternate setting and confirm with
Night Phase
(10 p.m. to 7 a.m.)
every 30 minutes
every 40 minutes
every 60 minutes
night phase 220 mmHg
INFO
.
START START
STOP STOP
INFO or press INFO
START START START
STOP STOP STOP
INFO
START START
STOP STOP
2001589-085 Revision G
to
.