Table of Contents
Advertisement
2.2 Install Disk
The installation steps for devices with mounting plate and disk bracket are different. Choose the installation
method according to your device model.
Device with mounting plate
1. Loosen the screws of the mounting plate on the side panels.
2. Turn the upper mounting plate in the shown direction, then remove the plate. Repeat the steps to remove
the lower mounting plate (for 8-HDD devices only).
3. Secure the disks on the mounting plate. Fix the screws according to the figure below. Avoid damaging the
disk in the process.
4. Put the mounting plate back in place. Connect the power cables and data cables as shown in the figure.
Repeat the steps to connect all the disks.
Data cable
5. Put the cover back in place, and secure it and the mounting plates with screws.
Power cable
3
Advertisement
Table of Contents
