Maintenance And Servicing - Bauer 22202E-B Owner's Manual & Safety Instructions

Maintenance and Servicing

procedures not specifically explained in this manual must
be performed only by a qualified technician.
tO preVent SeriOuS inJury FrOM acciDentaL OperatiOn:
turn the rotation Switch of the tool to its "OFF" position and unplug the tool from its electrical
outlet before performing any inspection, maintenance, or cleaning procedures.
tO preVent SeriOuS inJury FrOM tOOL FaiLure:
Do not use damaged equipment. if abnormal noise or vibration
occurs, have the problem corrected before further use.
cleaning Drain cleaner cables
1. Thoroughly flush Drain Cleaner cables with
clean water after every use. Doing so will
help prevent build-up of sediment and any
drain cleaning chemicals still on cable.
2. Once cables have been flushed,
carefully tip Drain Cleaner forward to
empty out remaining debris.
cleaning/Lubricating Housing
1. Drain Cleaner should be cleaned as needed
with hot, soapy water and/or disinfectants.
WarninG! tO preVent SeriOuS inJury:
risk of shock! Do not allow water to get into
motor or other electrical components.
2. Dry Drain Cleaner before storing or using again.
removing and installing Belt
1. Loosen Belt Guard Knob and slide Belt
Guard off top of Drain Cleaner motor.
2. Use screwdriver to slide belt off
back of Drain Cleaner drum.
3. Slide new belt into belt pulley above drum.
installing replacement cable
1. Remove old cable by pulling cable completely out.
Separate cable from drum-connecting cable.
Page 18 For technical questions, please call 1-888-866-5797.
3. Once cable is clean and dry, pull cable from drum.
4. Lubricate with oily rag as you feed
cable back into drum.
WarninG! tO preVent SeriOuS inJury:
Do not attempt to remove a rotating cable.
3. For Model 59533 (Power Feed Drain Cleaner),
hose out power-feed assembly with clean water.
4. Once dry, thoroughly lubricate with
lightweight machine oil.
5. If Drain Cleaner drum is removed or changed,
grease bearings with good general purpose grease.
4. Slide new belt onto rear of drum
until securely in place.
5. Slide Belt Guard pack into place above
Drain Cleaner drum. Tighten Belt Guard
Knob to lock Belt Guard back into place.
WarninG! tO preVent SeriOuS inJury: Do not
operate Drain cleaner without Belt Guard in place.
2. Connect new cable to drum-connecting
cable and feed cable back into drum.
Item 59533 59534