Bauer 22202E-B Owner's Manual & Safety Instructions page 16

power Feed Operation (For item 59533)
tO preVent SeriOuS inJury FrOM tWiSteD Or BrOKen caBLeS, caBLe enDS WHippinG arOunD,
MacHine tippinG, cHeMicaL BurnS, inFectiOnS, eLectric SHOcK anD OtHer cauSeS:
Follow operating instructions for your model explicitly.
Since drains likely contain hazardous chemicals or bacteria, wear
appropriate protective equipment, such as:
• anSi-approved splash-resistant safety goggles and respirator under face shield.
• Latex, rubber or other liquid barrier gloves under heavy-duty LeatHer work gloves.
Do not use a glove you are not currently wearing or a rag to hold the rotating cable. cloth materials
can get wrapped around the moving cable, leading to serious personal injury. Before use, inspect
gloves to be sure they are free of defects or loose sections that could get caught in Drain cleaner.
• rubber soled, non-slip shoes to help prevent slipping and electric shock.
1. Position Drain Cleaner two feet from drain.
2. Release all tension from Tension Knob,
then grab cable with both gloved hands and
push cable into drain until at least one foot of
cable is in drain. Retighten Tension Knob.
NOTICE
rotation Switch controls rotation of drum only. DO nOt uSe rOtatiOn SWitcH
reVerSe pOSitiOn WHiLe reMOVinG caBLe FrOM pipe. use reverse direction
only momentarily for relieving pressure or untangling cable from a blockage.
Warranty void if cable damaged from allowing motor to twist
excessively against blockage, or if drum is run in reverse long enough to unwind cable.
Page 16
tension
Knob
power Feed Lever
For technical questions, please call 1-888-866-5797.
3. Confirm Rotation Switch is in Forward position,
Tension Knob has been retightened, and
Power Feed Lever is in Forward (down)
position. Press Foot Switch to start feeding
cable further into drain. Make sure you can
operate Foot Switch while having at least one
hand on cable at all times. Also make sure
Rotation Switch on top of Drain Cleaner and
Power Feed Lever are within reach.
WarninG! Only one person should operate the
cable feed and the Foot Switch. Do not operate
Drain cleaner with one person controlling the cable
and another person controlling the Foot Switch.
this can cause cable to kink, twist, and break,
which can also lead to serious personal injury.
4. If cable becomes lodged (e.g., in a narrow part of
drain, in a drain trap, etc.), put Power Feed Lever
in Neutral position and allow cable to try
and work itself past obstruction. If cable still
won't pass obstruction, release pressure from
Foot Switch and use sharp downward thrusts to
try and pass obstruction. Once cable is past, put
Power Feed Lever in Forward (down) position,
press Foot Switch, and continue feeding.
Item 59533 59534